Anyone who works on firearms even occasionally, where you find someone has used a tapered screwdriver or a phillips, where the bit itself is not a perfect fit. The solution to a slipping screwdriver is too dip the screwdriver bit into a course can of abrasive paste and proceed to take out the screw. It works almost every time.


To make a bit magnetized, wrap a few turns of completely insulated heavy gauge wire around the screwdriver bit. Take both ends of the wire and touch both pos+ and Neg- terminals of a DC car battery. (Do not use AC) A car battery is fine, then hold the wire on the terminals for a few seconds. Make sure there is no bare metal touching the screwdriver or bit.

The Colt Peacemaker

Colt Peacemaker

The famous Colt .45. The gun that historians said won the west was the most popular full sized revolver in the late 1800’s.  The Peacemaker was also known as the Single Action Army (SAA), and the Frontier.  The Colt Revolver had become the most popular sidearm in history. 

The model 1873 had patents that were given to Charles B. Richards and W. Mason. Samuel Colt did not design the SAA due to the fact that he had passed away a decade earlier. The Colt was actually designed in 1872, and in 1873 the U.S. Army adopted this firearm and the black powder center-fire .45 cartridge to the troops. This new design replaced the outgoing Colt Model 1860 Army Percussion Cap revolvers that were in service at the time. The U.S. Army contracted with Colt to produce an estimated 38,000 Colts in two models: The Cavalry Model that had a 7 1/2 inch barrel, and the Artillery Model which had a 5 1/2 inch barrel.


Commercial production ceased in 1941, and brought back into production by popular demand in 1956. The production that ran from 1873 until 1941 were classified as first generation SAA’s. They have serial numbers below 357860. Colt SAA’s again ran a production from 1956 until 1974 then stopped production again in 1974. These were classified as second generation SAA’s and they had serial numbers range from 0001SA – 73319SA. After 1976 a third generation production began until production stopped again in 1981. Modern Colt SAA’s are made to fire .38 S&W Special, .44Spl, .357 Magnum, .44 Magnum, .22LR too name a few.

The Colt Peacemaker saw action throughout the Indian wars, The Spanish American War, The Range Wars, and others. Its use continued outside military use and became  very popular with civilian use. As a matter of fact the Model 1873 was brought back into production several times because of public demand for the original type. It was not only popular in the United States but became very popular in Europe as well.

Today the Single Action Army .45 is as popular today as it has ever been. Enthusiasts of the Old West have a passion for not only the Peacemaker but of the Old west culture and dress as well. Today many manufacturers are producing clones of the famous Peacemaker. The popularity of Cowboy Action Shooting has caused an increase in continuing the manufacturing of these clones.

Cowboy action shooters dress up in attire that is reminiscent of the old west. they usually have two Single Action Army Revolvers or there replicas at each side. Added to that they must have a lever action rifle that shoots the same cartridge as their revolvers at their sides. Too top it off they need to have a coach gun (shotgun) that is preferably double barrel however not required. All firearms must be actual or replicas 1900 or earlier.


Using these firearms the Cowboy Action Shooter uses each one of their firearms in competition shooting scenarios. Each shooter has a registered alias name that He or She uses at all these events. Check out the CASS (Cowboy Action Shooters Society) to get further information on how to join and have fun re-living the days of the old west and getting a chance to shoot those famous peacemakers.


If you would like to see the history about a particular firearm etc… leave a comment on my wordpress blog site. Please visit and join in.


Whenever you use screwdrivers on a firearm always use gunsmithing screwdrivers the blade is straight and not tapered this insures that the screwdriver won’t walk up the slot and ruin a perfectly good screw. Also make sure the blade fits completely in the slot and fills the slot as well. This will prevent damaging screw heads. I often see collector guns get spoiled just because someone used an ordinary screwdriver on gun screws. The heads are usually torn up.

These can be fixed to look like new with careful re-cutting and filing the screw head and then re-bluing the screw but it is easier to use the proper tool for the job!!

CW Gunsmithing and Firearms

Welcome to CW Gunsmithing and Firearms blog site. Here you will find interesting articles relating to firearms including history, gunsmithing, and political related articles specific to our constitution and the 2nd amendment.

I have been a certified Gunsmith for almost 31 years and love every minute I get to spend in my shop. It doesn’t matter how simple or complex a particular gun job is, I find it interesting and quite rewarding. The nice thing about being a Gunsmith is that you get to try to master different disciplines. These range from working with wood, and metal using various machines and hand tools for both metal and wood. If you want to work with wood you can make the gun stock or you can do checkering, accurizing a firearm by bedding a rifle etc… If you like metal working you can use a lathe and a mill to make gun parts including barrel making. You can re-chamber a rifle, mount scopes, apply bluing or engraving etc.. The jobs are really endless and therefore a day in the shop is never boring.

I started this site for a few reasons the first is to inform the reader about firearms and the history behind them. Another reason is to keep the public informed on your second amendment rights. Our freedoms are really not free. Many brave men and women have fought and died for our country to preserve our rights. If the public will not stand up for their freedoms and fight those that want to deny our rights, then our freedom will be lost. We can stand proudly together to protect our right to bear arms. If you are not a member of the NRA or other pro active gun rights organization then please join today to help make this stand.

Periodically I will post various tips concerning gunsmithing! I am not advising you to do any work on firearms I suggest that you have a professional gunsmith do any work that needs to be done. I am only offering suggestions about how one could go about working on firearms.

Thank you for visiting my site and I encourage you to leave questions and comments. Please be respectful in your comments and kindly refrain from any profanity. Civil debate is good and encouraged.

A well regulated Militia, being necessary to the security of a free State, the right of the people to keep and bear Arms, shall not be infringed.

Centenial Anniversarry Colt Model 1911

What a great way to start this blog with the centennial Anniversary of the Colt Semi Automatic Pistol; The Colt Model 1911. The history behind this firearm starts a decade earlier with a battle in the Philippine Islands. The U.S. Marines found themselves in a battle with radical insurgents. It was during this combat mission that the U.S. found themselves in need of a large caliber pistol for defense.

In February 1898 the battleship USS Maine was sunk in Havana Harbor. the United States went to war with Spain. Along with an invasion of Cuba, US Navy forces engaged, routed and destroyed the Spanish fleet at Manila Bay in March 1898, in one of the most lop-sided victories in naval history. US ground forces then went ashore to overthrow the Spanish colonial government and occupy the islands. Continuing the armed resistance they had previously shown against the Spanish, the Moro tribesmen of the southern islands engaged the American forces in a long bout of guerrilla warfare that ultimately lasted nearly 15 years. Much of the combat was at close quarters, where the Moros’ long-bladed kris knives were used to lethal effect. US troops were armed with either .30 caliber Krag or Springfield bolt-action rifles and .38 caliber double-action revolvers. While the .30 caliber rifles proved effective in stopping the attackers, the US troop’s handguns demonstrated an unnerving lack of stopping power, resulting in numerous reports of Moro warriors absorbing multiple pistol bullets while they continued to hack away at the Americans. Obviously the US troops’ morale suffered badly in this situation.

The combat pistol situation became so acute that old stocks of Model 1873 Colt revolvers in 45 caliber(commonly known as The Peacemaker), many of which dated back to the Plains Indian Wars were returned to active service, where they quickly demonstrated a much better track record of stopping an attacker with one well-placed shot.

The battlefield experience against the Moros resulted in the famous Thompson-LeGarde tests by the US Military in 1904. In these tests a variety of military cartridges of the day were tested for their penetration, ‘stopping ability’ and energy transfer, using both live and dead cattle at the target medium. While somewhat subjective by modern standards, the tests resulted in an official recommendation “…that a bullet, which will have the shock effect and stopping effect at short ranges necessary for a military pistol or revolver, should have a caliber not less than .45.” About this time two new armament technologies were also emerging – smokeless powder and the autoloading pistol. In 1906 the US Military, under the direction of General William Crozier of the Ordinance Department, began evaluating several pistol designs along with the suitability of a new cartridge that was designated the .45 Automatic Colt Pistol (or .45 ACP for short). As these military tests continued over the next several years, the Colt pistol began to emerge as the clear favorite.

The Colt pistol that was submitted for these military tests was designed by John M. Browning. Without a doubt the most innovative and visionary firearms designer of the late 19th and early 20th centuries, John M. Browning earned the lasting reputation as “The Father of Automatic Fire.” Browning’s design genius was not limited to pistols. Among his other military inventions were the Browning Automatic Rifle (BAR), numerous .30 caliber and .50 caliber Browning machine guns and the legendary Browning Hi Power, the first successful high-capacity autoloading pistol that soon became a worldwide standard for military sidearms.

Based on the short recoil principle of operation, the John M. Browning design for the US Military pistol trials was a magazine fed, single action semi-automatic pistol with both manual and grip safeties that demonstrated a level of durability, simplicity and reliability that no other pistol design of the era could match. In fact, during a 6,000 round test fired over two days in 1910 that was personally supervised by John M. Browning, his sample pistol became so hot that it was simply dunked in a pail of water to cool it for further firing. Browning’s sample reportedly passed the test with no malfunctions.

Since cavalry troops were going to be the primary combat users of the pistol, several specific design features, like the grip safety and lanyard ring, were mandated by the horse soldiers. (Nothing will turn a cavalry trooper into an infantryman faster than shooting his own horse by accident.) The Browning pistol design was formally adopted by the US Army on March 29, 1911, and thus became known officially as the Model 1911. The US Navy and US Marine Corps adopted the Browning-designed pistol in 1913.

The Browning-designed 1911 pistol was first tested in combat in Mexico in 1916. At that time Mexico was wracked by revolution and the most prominent of the rebel generals was Pancho Villa. During the early morning hours of March 9, 1916, Villa and his men attacked, looted and burned the small town of Columbus, New Mexico, resulting in the deaths of 18 US soldiers and civilians. Further attacks by Villa’s rebels in Texas resulted in the deaths of several more US soldiers and officials.

In response to the attacks, President Woodrow Wilson ordered General John J. “Black Jack” Pershing to lead a force of nearly 5,000 US soldiers onto Mexico to capture Villa. Many of the next generation of US military leaders got their first combat experience on this operation, including an ambitious young lieutenant by the name of George S. Patton. While the Punitive Expedition ultimately failed to capture Villa, it did provide the first major combat test of a number of new military technologies such as the airplane, wireless telegraph, motorized truck transport and the M1911 pistol.

The post-war era saw subtle refinements to the basic Model 1911 design, including the addition of improved sights, an arched mainspring housing, shorter trigger, longer grip safety spur and other ergonomic improvements. Collectively these improvements were completed in 1924 and resulted in the Model 1911A1. Not long after those modifications were formalized, John M. Browning died of a heart attack at the Fabrique Nationale (FN) factory in Herstal, Belgium, on November 26, 1926.

As the United States began to emerge as a major world military power, the Model 1911 saw combat service in a number of different conflicts, including many small actions in the Caribbean, South and Central America. These interventions were considered necessary to provide political, social and economic stability to the region and were sometimes called the Banana Wars.

During this era the Model 1911 also became a favorite sidearm of law enforcement officers nationwide, first in .45 ACP and later in the fast-stepping .38 Super. Among the more notable law enforcement users of the 1911 were members of the Texas Rangers, as well as federal agents of the Border Patrol, Prohibition Service and the FBI.

December 7, 1941 brought the Japanese air attack on Pearl Harbor and US entry into WW II. The conflict represented the largest war mobilization in US history, with more than 16 million American men and women serving in the armed forces in every theater of the conflict. The Model 1911 was the standard sidearm for almost all US military forces fighting on the ground, at sea and in the air. Total military production of the Model 1911 was nearly 3 million pistols. Combined with the millions of Browning machine guns and BARs produced over the decades, it is easy to see that the guns designed by John M. Browning played a major role in defending freedom and crushing tyranny. The Model 1911 continued to serve with distinction at the side of American servicemen for most of the remainder of the 20th century including Korea, Viet-Nam and other conflicts.

With the end of WW II, millions of US servicemen returned from combat service around globe, eager to enjoy a new life of peace and prosperity. With that post-war prosperity came plenty of leisure time for recreation, and the shooting sports in America literally boomed! Shooting clubs and leagues sprouted up in every city and town, at colleges, high schools, factories and local ranges.

Today the 1911 remains the most popular pistol to date. No matter how many subtle improvements have been made through the years, the basic design of John Browning’s 1911 remained unchanged. Thanks in part to John Browning many servicemen are alive today because of this famous pistol; The 1911 Colt Pistol in caliber .45 ACP (Auto Colt Pistol).

Browning Firearms.

5416011605 Monday - Friday 9;00am -5:00pm Saturdays 10:00am - 2:00pm